ATJ7056 SLEEVE.  Transmission half shaft oil seal sleeve.  

Fits to later sliding hub axle shafts and early standard (flanged) axle shafts on the tractors listed below.

If your tractor has a standard (flanged) type axle and was manufactured after the change points shown see part number ATJ7784 SLEEVE.

If you have a Nuffield Universal Tractor or an early Nuffield 4DM see part number NT1167 SLEEVE.

Made in the UK, Case hardened as per original Nuffield specification.

Fit with ATJ1024K SEAL KIT.

Dimensions

• Outside diameter: 3³/₈” inch (86mm)
• Inside diameter: 2³/₄” inch (70mm)
• Length: 1⁵/₈” inch (41mm)

Important: Check length before ordering as this will indicate which type of sleeve you require.

This sleeve has to be preheated to fit and special care must be taken when fitting.  We highly recommend you refer to the WORKSHOP MANUAL or call our parts team for further information.

View number 4 in this parts illustration of Nuffield transmission and half shaft assembly.

Fitted to tractors:

• Nuffield Universal Three (3DL), Universal Four (4DM)
  (Serial number DE10388 on)
• Nuffield 342, 460
• Nuffield 10/60
  (up to serial number 89156)
• Nuffield 10/42
  (up to serial number 89756)
• Leyland tractors with sliding hub axle.
• Marshall tractors with sliding hub axle.

Alternative part number: NT7244